22 XT8000E Series Portable Generator
NOTE:
Your generator can still be operated using the recoil
starter.
4.4 — Generator Storage
The unit should be started at least once every 30 days
and be allowed to run at least 30 minutes. If this cannot
be done and the unit must be stored for more than 30
days, use the following information as a guide to prepare
it for storage.
Allow unit to cool entirely before storage.
4.4.1 — Long Term Storage
1. Treat the fuel with a commercially available fuel sta-
bilizer. Operate the engine for 10-15 minutes to circu-
late treated fuel into the fuel lines and carburetor.
Turn the fuel valve off and run the unit until it shuts
down. The fuel may be left in the tank or drained into
a suitable container.
2. Drain oil from crankcase. Refill with recommended
grade oil.
3. Remove spark plug and pour about 1/2 ounce (15
ml) of engine oil into the cylinder. Cover spark plug
hole with rag. Pull the recoil starter several times to
lubricate the piston rings and cylinder bore. A fogging
agent can be used in place of oil.
Avoid spray from spark plug hole when crank-
ing engine.
4. Install and tighten spark plug. Do not connect spark
plug wire.
NOTE:
Allow the unit to cool completely.
5. Clean the unit’s outer surfaces. Check that cooling
air slots and openings on the unit are open and unob-
structed.
6. Store the unit in a clean, dry place.
4.4.2 — Other Storage Tips
• If possible, store the unit indoors and cover it to give
protection from dust and dirt. BE SURE TO CLOSE
THE VALVE ON THE FUEL TANK.
• Cover the unit with a suitable protective cover that
does not retain moisture.
NEVER cover the generator while engine and
exhaust areas are warm.
To Next Page
Loading...
Need help?
General
