GA-VM900M Motherboard - 32 -
English
2-2 Advanced BIOS Features
Init Display First
This feature allows you to specify the first initiation of the monitor display from the installed PCI
graphics card, PCI Express graphics card, or the onboard VGA.
PEG Set Init Display First to PCI Express VGA card. (Default value)
PCI Slot Set Init Display First to PCI VGA card.
Onboard Set Init Display First to onboard VGA.
Dual display function
This feature allows user to enable or disable the dual display function.
Enabled Allows the onboard graphics to be active when an external graphics card is
installed.
Disabled Only allows output from either the onboard graphics or the external graphics
card. The onboard graphics will be disabled when an external graphics card is
installed. (Default value)
VGA Share Memory Size
This feature allows you to allocate part of the system memory to the onboard VGA when the
system boots up.
64M Set VGA share memory size to 64 MB. (Default value)
128M Set VGA share memory size to 128 MB.
256M Set VGA share memory size to 256 MB.
Hard Disk Boot Priority
Select boot sequence for onboard(or add-on cards) SCSI, RAID, etc.
Use < > or < > to select a device, then press<+> to move it up, or <-> to move it down the list.
Press <ESC> to exit this menu.
First / Second / Third Boot Device
Floppy Select your boot device priority by Floppy.
LS120 Select your boot device priority by LS120.
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
Advanced BIOS Features
Init Display First [PEG]
Dual display function [Disabled]
VGA Share Memory Size [64M]
` Hard Disk Boot Priority [Press Enter]
First Boot Device [Floppy]
Second Boot Device [Hard Disk]
Third Boot Device [CDROM]
Password Check [Setup]
HDD S.M.A.R.T. Capability [Disabled]
CPU Hyper-Threading
(Note)
[Enabled]
Limit CPUID Max. to 3
(Note)
[Disabled]
No-Execute Memory Protect
(Note)
[Enabled]
CPU Enhanced Halt (C1E)
(Note)
[Enabled]
CPU Thermal Monitor 2(TM2)
(Note)
[Enabled]
CPU EIST Function
(Note)
[Enabled]
Virtualization Technology
(Note)
[Enabled]
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level`
(Note) This item will show up when you install a processor which supports this function.