3. Installation
3.1 Installation requirements
3.1.1 Arrangement
Before installation it is required that project specific drawing are made. This drawings must include connection
drawings and lights arrangement drawings.
In order to make drawings following information needs to be available:
- name of lamps
- color of lamps
- position of lamps
- type of lamps (double or single)
- power supply of lamps
Arrangement can be easily prepared as shown bellow (example is shown for factory arrangement)
Empty form can be found in appendix.
Connection drawing can be easily prepared based on maximum configuration shown on connection
drawing on next page. Standard configuration is shown on page.
Always match arrangement with connection drawing!!!
No. Name
Color*
PORT
STBD
No. Name
Color*
Spare
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Possible navigation
lights positions
Possible signal
light positions
Example of mast shape
(it can be arranged in
each position between lights)
1
2
3 4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
ANCHOR FWD
MASTHEAD FWD
PORT
STARBOARD
MASTHEAD AFT
N.U.C. UPPER
R.A.M.
N.U.P. LOWER
ANCHOR AFT
STERN
W
W
R
G
W
R
W
R
W
W
1 2
3 4
5 6
7 8
9 10
11
12
1
2
3
4
5
6
7
8
9
10
11
12
SUEZ RED
SUEZ RED
SUEZ WHITE
SUEZ WHITE
SUEZ GREEN
SUEZ RED
SUEZ RED
SUEZ WHITE
SUEZ WHITE
SUEZ RED
SUEZ WHITE
SUEZ RED
R
R
W
W
G
R
R
W
W
R
W
R
Navigation lights Signal lights
Spare Y/N - in case of
doulbe lights mark Yes
Maximum 13 double
navigation lights
For more than 10 double navigation lights
additional input module ITNL-3 has to be used
(not part of standard delivery)
Maximum 26 signal lights
For more than 13 signal lights
additional input module ITSL-7
or ITSL-13 has to be used
(not part of standard delivery)
*Color: W (white); R (red); G (Green); Y (Yellow); B (blue)
8
To Next Page
Loading...
Need help?
General
