4 Installation
4.1 Mounting Instructions
1. In order to achieve optimal performance, the ambient temperature should be lower than 45℃.
2. For easy maintenance, we suggest to install the inverter at eye level.
3. Inverters should not be installed near flammable and explosive items. Strong electro-magnetic
charges should be kept away from installation site.
4. Product label and warning symbols should be placed at a location that is easy to read by the
users.
5. Make sure to install the inverter at a place where it is protected from direct sunlight, rain and
snow.
4.2 Equipment Installation
4.2.1 Select The Installation Location
1. Take the bearing capacity of the wall into account. The wall (such as concrete walls and metal
structures)should be strong enough to hold the weight of the inverter over a long period of
time.
2. Install the unit where it is accessible to service or do the electrical connection.
3. Do not install the unit on the wall of flammable material.
4. Make sure the installation location is well ventilated.
5. Inverters should not be installed near flammable or explosive items. Any strong electro-mag-
netic equipment should be kept away from installation site.
6. Install the unit at eye level to for convenient operation and maintenance.
7. Install the unit vertically or tilted backwards of no more than 15 degrees, and wiring area
should should be facing downwards.
For dissipation of heat and convenience of dismantling, clearnaces around the inverter must
meet the standard as shown below :
The installation position should not prevent access to the disconnection means.
Upward
Downward
Front
Both sides
-------------- 200mm
---------- 500mm
----------------- 300mm
---------- 500mm
500mm
300mm500mm
200mm
500mm
Max
15°
4.2.2 Mounting Procedure
1. Use the wall-mounted bracket as a template and drill 6 holes on the wall, 10 mm in diameter
and 80 mm deep.
2. Fix the wall mounting bracket on the wall with six expansion bolts in accessory bag.
3. Hold the inverter by the groove on it.
4. Place the inverter on the wall-mounted bracket.
SDT series
117.5mm
104.5mm
457mm
400mm
228.5mm
Backboard Installation
Expansion Pipe
Nut
DT series
457mm
400mm
177mm
163.5mm
228.5mm
Backboard Installation
Expansion Pipe
Nut
Accmulated snow
Keep away
from sunlight
Keep dry
Keep it clear
of snow
Sun Rain
0807
To Next Page
Loading...
Need help?
General
