li
6. Starting a Washing Program
Wash
cycle table
Cycle Selection
Description Detergent
Running
Energy
Water
Program
Time
Information
of Cycle Pre/main
(min)
(kWh)
(L)
2o>
Crystal wash cycle to be used
Main wash(40
°
C)
for more delicate
items
which
Rinse
20 118 0.900 11
-=-
are sensitive to high
Hot rinse
Crystal
temperatures.
Drying
Pre-wash
For the heaviest soiled loads,
Main wash(60
°
C
0
such as pots, pans, casserole
Rinse1
-=-
dishes and dishes that have
Rinse2
5/25
180 1.300 16
Intensive
been sitting with dried food
Hot rinse
on them for a while.
Drying
eco
For normally soiled
loads,
Pre-wash
(•EN50242)
such as pots, plates, glasses
Main wash(44
°
C)
5/25 237 0.900 11
(Standard
and lightly soiled pans.
Hot rinse
Program)
standard daily
cycle.
Drying
{96
A shorter wash for lightly
Main wash(40
°
C)
soiled loads that do not
15
39
0.500 7
Rapid
need
drying.
Hot rinse
�
To
rinse dishes that you
plan to wash later that day
Pre-wash
/
11 0.100 4
Pre-Rinse
* EN 50242: this program is the test cycle
The information for comparability test in accordance with EN50242,as follows:
- Capacity: 13
settings
- Position
of
upper basket: Low position
- Rinse aid setting: 6 ( or 4 for four setting dispenser)
Turning on the Appliance
Starting
a
wash cycle ...
Draw out the lower and upper basket, load the dishes and
1. push them back. lt is recommended
to
load
the
lower basket first, then the upper one (see
the
section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,
Detergent and Rinse Aid").
2. lnsert the plug into the socket. The power supply is 220-240V AC 50
Hz,
the specification of the
socket is 12A250 VAC.50 Hz.
Make sure that the water supply is turned on to full pressure. Close the door, press the"Power"button,
Press the "Program" button to select a desired "Wash cycle". (See the section entitled "Wash
Cycle Table"). With
a
little force
to ensure
the
door
is properly
closed.
NOTE: A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by pressing "Power" button.
Change the Program
Premise: A cycle
that
is underway can only be modified if
it
has only been running for a
short time.
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section
entitled " Fill in the Detergent " ).
Press"Power" button to cancel the program, and turn on it again ,then you can change the
program to the desired cycle setting (see the section entitled "Starting a wash cycle ... ").
NOTE: If you open the door when washing, the machine pauses and warning alarm rings, the display
appears E1. When you close the door, the machine will keep on working .
The 5 program lights show the state
of
the dishwasher:
a) One of the program lights on--> cycle running
b) One of the program lights blinking -->pause
NOTE: If all the lights begin to glimmer, that indicates the machine is out of order, please turn off
the
main power and water supply before calling
a
service.
Forget
to
Add Dish
A forgotten dish can be added any time before the detergent cup opens.
1 Open the door a little to stop the washing.
2 After the spray arms stop working, you can open the door completely.
3 Add forgotten dishes.
4 Close the door, the dishwasher will work after
ten
seconds.
 WARNING!
Open
the door
when appliance is working,The
buzzer
rings 10
times
and the
LED1 ,LED3
flash.
lt
is dangerous to
open
the door
when washing,
because the hot water may scald
you.
Switch Off the Dishwasher
The
buzzer
rings
6
limes,
only in
this case the
programme
has
ended.
1.Switch
off
the
dishwasher by pressing
the
" Power " button.
2.Turn off the water tap!
Open
the door
carefully.
Hot steam may
escape
when the door is opened!
■Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
15 minutes before removing
from the
appliance.
■Open
the dishwasher's door, leave it ajar
and
wait a
few
minutes before
removing
the dishes. ln
this way they
will be
cooler and the drying
will be
improved.
Unloading
the dishwasher
lt
is normal
that the dishwasher is wet inside.
Empty
the
lower
basket first
and
then the
upper one. This will
avoid water
dripping from
the
upper
-b-as_k_e_t
o_n_t_o-th_e_d-is_h_e_s-in-th_e_lo_w_e_r_o_n_e_.
--------------------
To Next Page
Loading...
Need help?
General
