12
|
BIOBASIC MANUAL
Installation
When setting up in an ordinary scenario that is not subject to
regulations for EN 60079-15 zone 2:
The appliance may be connected in accordance with applicable local
heavy current regulations.
Note that there are special regulations for products that are in
accordance with EN 60079-15 zone 2.
The appliance has been manufactured in accordance with EN 60079-
15: Electrical apparatus for explosive gas atmospheres - Part 15: Type
of protection “n”. Zone 2 is the applicable zone. If the appliance is to be
installed in a zone 2 environment, specialist personnel should perform
the installation, or be consulted beforehand, in order to ensure that
the appliance is installed in compliance with the guidelines currently
contained in the standard.
The cabinet is intended for connection to alternating current. The
connection values for voltage (V) and frequency (Hz) are given on the
type/number-plate.
The power cord from the mains is plugged in
the terminal box on the back of the cabinet.
The plug is then xated in place by the
hanger that is built into the terminal box.
Please note that the hanger should be tted
tightly around the plug, as shown.
Connecting to electricity
To Next Page
Loading...
Need help?
General
