16
|
BIOBASIC MANUAL
Start up
Turn On/O:
Press shortly to turn the cabinet on and press for 6 seconds to turn
the cabinet o.
Initiation procedure:
Readout of the software version and variant will occur shortly after
turning the cabinet on. The cabinet will then automatically start a
defrost-cycle, and terminate it again after a system check.
The cabinet is ready when the temperature is displayed.
The cabinet will always commence operation when initially connected
to a power supply. For instance after a power outage or when plugging
the cabinet in for the rst time.
Setpoint temperature adjustments:
Temperature adjustments are done by pressing for 3 seconds,
prompting the set point temperature. Adjust the set point temperature
by either pressing or . Conrm the settings by pressing .
Servicing:
Make sure the appliance is switched o at the socket before service is
performed on the cabinet. It is not sucient to switch o the cabinet on
the On/O button, as current will persist in some electrical parts of
the cabinet.
If fuses or similar are to be replaced, the appliance must be moved to a
no-risk area for safe replacement.
General introduction to the controller interface
To Next Page
Loading...
Need help?
General
