GDS3710 User Manual
Version 1.0.7.8
- GXP21XX phones receive the GDS3710 video using JPEG streaming
this means that it will receive video if early media is enabled or disabled.
Note: This field supports a Maximum of 256 characters.
Maximum Number of
Dialed Digits
Configure the maximum digits allowed to dial in the keypad. Once the
configured condition satisfied, the device will send out the digit to call
automatically without pressing #. Disabled if set to 0.
Defines the timeout (in seconds) for no key entry. If no key is pressed after
the timeout, the digits will be sent out without pressing #. The default value
is 4 seconds. The valid range is from 1 to 15.
Configure a schedule for the Doorbell button, once configured, the
doorbell with turn ON/OFF based on configured schedule.
Default setting is “All Day”.
Remote PIN to Open the
Door
Configures PIN code stored in the GDS3710, remote SIP phone needs to
input and match this PIN (the PIN is sent via DTMF while in call) so that
the GDS3710 can open the door.
Note: For enhanced security, when the call is initiated from GDS then only
the numbers existing in “White List” will be able to use DTMF PIN to open
door remotely.
Three options are available: Private Card PIN, Unified PIN or Card and
Private PIN.
• Private PIN: Means every member has a private PIN, the GDS will
record who unlocked the door every time. Users need to enter the
following sequence from the GDS3710 to open the door [*Virtual
Number*Private PIN#].
Notes:
1. When Local PIN type is set to private PIN, users can also open
the door by swiping their cards.
2. If “Disable Keypad SIP Number Dialing” is checked, users will be
able to open door using private PIN with following sequence
[Private PIN#].
Note: Door can still be opened by Card and with the sequence
[*Virtual Number*Private PIN#].
To Next Page
Loading...
Need help?
General
