EN - 18
4. Pull PTO knob up to on position.
IMPORTANT: Never engage the PTO if the
mower is plugged with grass or other
material. This may cause damage to the
electric clutch.
5. Move steering levers to begin mowing.
IMPORTANT: Aggressive turning can scuff or
damage lawns. Always keep both wheels
rotating when making sharp turns. DO NOT
make turns with inside wheel completely
stopped. For minimum turning radius, slowly
reverse inside wheel while moving outside
wheel slowly forward.
For Best Mowing Results
1. Cut grass when it is dry.
2. Keep mower blades sharp.
3. Keep mower deck properly leveled.
4. Adjust anti-scalp wheels to prevent
scalping.
5. Do not set height of cut too low. For very
tall grass, mow twice.
6. Do not travel too fast.
7. Mow with engine at full throttle.
8. When mulching, only remove 1/3 of grass
length per cutting. Do not cut more than
2.5 cm (1") at a time.
9. Discharge clippings into areas already
cut.
10. Change cutting pattern with each
mowing.
11. Do not allow grass or debris to collect
inside mower deck. Clean after each use.
STOP THE ENGINE
1. Move steering levers to the neutral
position.
2. Engage parking brake.
3. Reduce throttle to 3/4 fast position.
4. Push PTO switch down to the off position.
5. Move throttle control lever to slow
position.
6. Turn key to off position and remove from
ignition.
MOVE UNIT MANUALLY
Bypass the transaxles to move the unit with
the engine off.
1. Place steering levers in neutral position
and engage parking brake.
2. Stop engine, remove key and wait for
moving parts to stop and for hot parts to
cool.
3. Pull both transaxle bypass levers out into
bypass position. See Figure 14.
4. Release parking brake and push unit to
desired location.
5. Engage parking brake.
WARNING: AVOID INJURY.
Move the steering levers slowly
and keep the throttle at slow
speed until you learn how to
operate the unit.
Direction
of Travel
Lever Position
Forward Push both levers
forward from
neutral position.
Reverse Pull both levers
backward from
neutral position.
Right Turn Push left lever
farther forward
than the right
lever.
Left Turn Push right lever
farther forward
than the left lever.
Stop Return both
levers to neutral
position.
WARNING: AVOID INJURY.
Wait for all moving parts to
stop before leaving operator’s
position.
To Next Page
Loading...
Need help?
General
