Gravely Pro-Stance 36 User Manual

EN - 26
Replace Relay
NOTICE: Relays are interchangeable. Use
only quality replacement parts. See Service
Parts on page 20.
See Figure 27.
1. Remove defective relay.
2. Determine cause of relay failure and
repair condition.
3. Install new relay.
ADJUST TRANSAXLES
Check for Excessive Creep
1. Operate unit for a minimum of 5 minutes
to warm hydraulic system.
2. Stop engine and engage parking brake.
3. Chock front wheels and support unit so
both drive wheels are off the ground.
4. Remove drive wheels.
5. Start engine, move throttle lever to fast
position and release parking brake.
6. Move steering levers forward and
backward 5 or 6 times and then return
levers to neutral position.
7. Check wheel hubs for rotation.
• If there is only slight rotation, stop
engine, reinstall wheels and lower unit
to ground.
• If there is excessive rotation, adjust
neutral position. See Adjust Neutral
Position on page 26.
Adjust Neutral Position
If wheel hub has excessive rotation after
checking for excessive creep, adjust neutral
position.
1. Loosen the return to neutral screw on
transaxle. See Figure 28.
2. Slowly turn transaxle control arm in the
opposite direction of hub rotation until hub
stops. See Figure 29.
WARNING: AVOID INJURY.
This adjustment requires
operating the engine. Use
extreme care to avoid contact
with moving parts and hot
surfaces. Be sure rear of unit is
well supported and secure
before starting engine.
START/RUN
RELAY
STARTER
SOLENOID
RELAY
PTO
RELAY
OPERATOR
PRESENCE
AUX
5AMP
CHARGING
20AMP
PTO
10AMP
CONTROLS
10AMP
TIME DELAY RELAY
07700221
TIME DELAY
10AMP
2
1
Figure 27
1. Relays
2. Fuses
Figure 28
1
Figure 29
2
1. Return To Neutral Screw
2. Transaxle Control Arm
Axle Direction

Gravely Pro-Stance 36 Specifications

General

Brand	Gravely
Model	Pro-Stance 36
Category	Lawn Mower
Language	English