EN - 13
5. Rotate ROPS to operating position and
secure with lock pins. Secure lock pins
with hairpins. See Figure 7.
6. Remove two eccentric spacers, two
round head square neck bolts and two
locking nuts from hardware bag.
7. Rotate steering levers to operating
position and install eccentric spacer
between steering lever plates. Secure
with hardware. See Figure 8.
8. Adjust steering levers. See Adjust
Steering Levers on page 32.
9. Check tire pressures and inflate to
recommendation. See Specifications on
page 45.
10. Remove battery from unit and charge.
See Charge Battery on page 29.
11. Make sure deck is level. See Level and
Pitch Mower Deck on page 40.
12. Ensure all hardware is tight.
Figure 7
1. ROPS
2. Lock Pin
3. Hairpin
1
2
3
Figure 8
1. Eccentric Spacer
2. Steering Lever
3. Steering Lever Plate
1
2
3
WARNING: AVOID INJURY.
Explosive separation of tire and
rim parts is possible.
• DO NOT inflate tires above
maximum pressure listed on
tire sidewalls.
• DO NOT inflate tires with a
compressor; use a hand
pump.
• DO NOT stand in front of tire
assembly when inflating. Use
a clip-on chuck and extension
hose long enough to allow you
to stand to one side.
• DO NOT mount a tire without
proper equipment and
experience.
To Next Page
Loading...
Need help?
General
