20 1/00
TIRES
Before each use make a visual check of tires. The correct
air pressure is 12-15 psi (83-103 kN/m
2
) for the rear tires
and 20-25 psi (138-172 kN/m
2
) for the front tires.
LUBRICATION
IMPORTANT: Wipe each fitting clean before and after
lubrication.
Steering system and Speed Selector components should
be lubricated every 50 hours of operation or every
3 months whichever comes first. (Figure 11)
Lube fitting locations are:
– each deck push arm (2)
– Hydro Idler (1)
– front axle pivot (1)
Apply Sten Mix Hi-Temp Grease or equivalent to the lube
fittings. Order P/N: 00036700 - ten pack of 14 oz.
cartridges.
When using Sten Mix Grease for the first time, all
components should be thoroughly cleaned prior to
lubricating.
Apply oil at all pivot points and pin connections.
FASTENERS
Each day before operating, check mower blade mounting
hardware and all other fasteners. Replace fasteners that
are missing or damaged. Tighten all nuts and bolts to
their correct torque value.
OF1631
2
3
1
4
5
6
1. Hydro Belt
2. Spring
3. Idler
4. Engine Sheave
5. Right Hand Hydrostat
6. Left Hand Hydrostat
Figure 9
50" and 60" Belt Layout
1. Long Mower Belt
2. Short Mower Belt
3. Springs
4. Idlers
5. Mower Clutch Sheave
1
3
2
4
OF1640
5
Figure 10
REF LUBRICATION QTY DESCRIPTION-
LOCATION
INTERVAL
REF
1 GREASE 2 CASTER PIVOT 50 Hrs. 1
2 GREASE 1 AXLE PIVOT 400 Hrs 2
3 GREASE 2 PUSH ARM PIVOT 50 Hrs 3
4 GREASE 1 PUSH ARM PIVOT 50 Hrs 4
OIL ALL PIVOT POINTS,
PIN CONNECTIONS
50 Hrs
OF1791
1
2
2
3
3
4
Figure 11
To Next Page
Loading...
Need help?
General
