Gree 13-04582 User Manual

Casement window
1. It is recommended to replace the
screen with a clear plexiglass
panel (1/4'') fitted to the size of
your window screen.
2. Cut a hole to the same size as the
window oval adaptor of the
exhaust hose - approximately
13,3 cm (5-1/4”).
3. Correctly fit on the adaptor.
4. Fix it on the plexiglass using
4 screws (not included).
Sliding windows or patio door
1. Install the window slider kit
vertically or horizontally within the
inside frame (vertically for a patio
door). If necessary, screw the slider
kit on the frame.
2. Close the window onto the window
kit to form a tight seal.
3. Attach the exhaust hose adaptor to
the window slider kit; the adaptor
tabs will lock into place the
adaptor to the window kit.
INSTALLATION
7
NOTE :
Using the window slider kit may make it difficult to correctly close and/or lock the window.
Additional safety precautions should be considered.
• Make sure to correctly install and insulate the window slider kit. It must perfectly fit into
the window. The length can be adjusted. The three pieces are easy to cut and slide well
into each other.
• Tape the edge around the slider kit to stop insect or bug intrusion (tape not included).
HUNG
WINDOW
CASEMENT
WINDOW
INSTALLATION BY WINDOW TYPE
T
I
M
E
R
M
O
D
E
SLIDING
WINDOW or PATIO DOOR
Note : model may
differ from illustration

Gree 13-04582 Specifications

General

Brand	Gree
Model	13-04582
Category	Air Conditioner
Language	English