22
Installation in a double-hung sash window
(Note: If the inner width of window is below 20.5"(520mm), please remove the
adjusting panel from window panel and then cut the window panel to make its width
the same as the width of window.)
1. Install rear clip — aim the rear clip(upper) at the rear clip(lower),fix them together,
press the clasp forcibly in to the groove.
adjusting panel
window panel
cut
clasp
rear connector (lower)
rear connector (upper)
window panel
2. Clamp joint B+C into the inner side of window panel along the direction of arrow.
joint B+C
inner side
3. Fix the protective grille on joint B+C with screws.
washer and bolt.
screws
protective grille
4. Fix the support on the outer side of window panel with nuts, spring washer,
To Next Page
Loading...
Need help?
General
