10. Removal Procedure
10.1 Removal Procedure of Indoor Unit
Warning Be sure to wait
10 minutes
after turning
off all power supplies before disassembling work.
Removal Procedure
panel
filter and
pan
el case
Push the convex parts the left and right sides
of the front panel, and then lift the front panel.
Unscrew the screws fixing the display cover and
pull out the plug.Forcibly lift the front panel up-
wards from the clasps to take it out.
Top the middle section of air filter from the clasps
at both sides.Pull the air filter forward to remove
it.
Unscrew the 1 screw on press plate to open the
press
Push out the axile bush in the middle of
Then slightly bend the to
remove it.
Unscrew the 7 tapping screws fixing the front
case, and turn the front case backwards to re-
move it.
wire board.
air deflector
air
deflector
.
screws
panel
display cover plate
screw
air deflector
axile bush
filter
clasps
for a minimum of
Remove
Remove
Remove
Remove
on
wire-pressed clamp
wire-pressed clamp
swing louver
55
To Next Page
Loading...
Need help?
General
