10
Care and maintenance
Warning
Turn power off and pull out the power plug before cleaning air conditioner.
Or it may cause the electric shock.
Never dampen the air conditioner, it can cause the electric shock.
And never sprinble water on the unit.
Volatile liquid (e.g. thinner or gasoline) will damage the air conditioner. (So wipe the units
with a dry soft cloth, or a cloth slightly moistened with water or cleanser.)
Clean the surface panel
Take down the front panel
Clean the front panel
To install the front panel
Use a soft brush with little water and detergent to clean, then to dry it
in the shade.
Clean the filter
Take down the filter
Cleaning
Reinsert the filter.
NOTE:
Never to put the front panel or filter directly under the sun.
Never use water above 45℃ to wash the filters, or it could cause deformation or discoloration.
Never parch it by fire, or it could cause a fire or deformation.
According to the arrow head direction to open the front panel,
take off the bolt of both end, take off the front panel.
Bolt
Reinsert the front panel into axial seat, then reattach the front panel
and clasp.
Open the front panel to an angle, then push the filter upward, and
pull it outward and take it off, refer to right figure.
To clean the filter by dust collector or water, when the filter is too dirty (such as greasy)
could use the warm water with neutral cleaning ( below 45
℃
) for cleaning, then dry it
in the shade, as shown in right figure.
Reinstall the filter, the filter surface remarked with "Front " face to yourself,
then recover the front panel and clasp it.
Ultra thin split unit series
To Next Page
Loading...
Need help?
General
