Selection of installation location
Indoor unit
Outdoor unit
Be sure that the installation conforms to the installation dimension diagram.
Select a location where is easy to remove and clean the filter.
Install in a location where is 1m or more away from other electric appliances such as television, audio devices, etc.
Be sure to leave enough space to allow access for routine maintenance. The height of the installed location
should be 200cm or more away from the floor.
Be sure that the installation conforms to the installation dimension diagram.
Install in a location where is strong enough to withstand the full weight and vibration of the unit.
Avoid a location where there is heat source, steam or inflammable gas.
Install in a location from which the condensation water can be drained out conveniently and that is permitting easy
connection with the outdoor unit.
The inlet and outlet should be far away from the obstructions so that the outflow air can reach all parts of the room.
Select a location from which noise and outflow air emitted by unit will not inconvenience neighbors.
Select a location where there should be sufficient ventilation.
Thereshould be no danger of flammable gas or corrosive gas leaks.
T he outdoor unit inlet and outlet vent should not be covered.
T he installation position should withstand the full weight and vibration of the unit, and
make sure that the installation work can be carried through safely.
NOTE:
Install in the following place may cause malfunction. If it is unavoidable, contact the dealer please.
The place where oil (machine oil) is used.
The place where a lot of salinities such as coast exists.
The place where a sulfured gas such as the hot spring zones is generated.
The palce where high-frequency waves are generated by radio equipment,
welders and medical equipment.
Other place with special circumstance.
To Next Page
Loading...
Need help?
General
