Central Air Conditioner Thermostat
8
e. Connect the FFP on the control
board.
f. Put the panel to clasps of the back cover
and press by proper force its two lower
sides.
5 Thermostat operations
The thermostat backlight will be off
after 20 continuous seconds without a key
press on the panel or the remote controller.
Then, any key press on the panel will
enable the backlight (that will flash once
if the user operates the remote controller)
indicating that the user can begin to use the
thermostat.
Notes:
Remote controller model YB1FA
(MOTO) is recommended for WK-011PM,
not for WK-010PM which does not support remote control.
Figure 1