CAUTION
Do not overtighten the adjusting screws, as this could
damage the cutter bar. Tighten both screws during final
adjustment.
WARNING
Clean any grinding compound or debris from the cutter bar
blade, reel blade, pinions and pawls.
NOTE
Use industrial or valve lapping compound between 100 and
240 grit. Lubricate the axle and pinion with a light file of
wheel bearing grease.
11.2 MAINTENANCE TIP
The machine is relatively low maintenance. For consistent
cutting follow the below instructions:
• Always keep the cutting bar properly adjusted. Refer to
the instruction manual for further directions.
• Regularly clean and lube cutting edges with light spray
oil.
CAUTION
The machine has a difficult time with tall weeds such as
dandelions which most times will cause the weeds to bend
instead of cut. Cut often to prevent long lengths.
12 CLEAN AND STORAGE
• Clean the exterior of the machine thoroughly using a soft
brush and cloth before storing. Do not use water, solvents
or polishes.
• Turn the mower on its side to clean the blade area.
• Store the mower in a dry place. Do not place other objects
on top of the mower during storage.
WARNING
Do not place hands in the mower near blades. If grass
cuttings are compacted in the blade area, remove using a
wood or plastic cleaning tool appropriate for the cleaning of
the blades.
13 TROUBLESHOOTING
Problem Possible cause Solution
Unsatisfying cut-
ting result.
Blade clearance is
too wide.
Adjusting the
blade clearance,
refer to mainte-
nance section.
Machine is too
noisy and difficult
to operate.
Blade clearance is
too narrow.
* If you cannot find the solution to these problems, please go
to the service center.
14 TECHNICAL DATA
Rotor 5 Steel blades
Cutting path 14'' (35 cm)
Height adjustments 1.06 - 2'' (2.7 - 5.1 cm)
Rear bag capacity 7 gal
Weight 22 lbs. (10 kg)
15 LIMITED WARRANTY
YEAR
ANS
AÑOS
LIMITED WARRANTY
GARANTIE LIMITÉE
GARANTÍA
LIMITADA
3
Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of three (3)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been hired or rented for industrial/commercial use, and that
have been maintained in accordance with the instructions in
the owners’ manual supplied with the product from new.
ITEMS NOT COVERED BY WARRANTY:
1. Any part that has become inoperative due to misuse,
commercial use, abuse, neglect, accident, improper
maintenance, or alteration; or
2. The unit, if it has not been operated and/or maintained in
accordance with the owner's manual; or
3. Normal wear, except as noted below;
4. Routine maintenance items such as lubricants, blade
sharpening;
5. Normal deterioration of the exterior finish due to use or
exposure.
HELPLINE:
Warranty service is available by calling our toll-free helpline,
at 1-888-909-6757.
TRANSPORTATION CHARGES:
Transportation charges for the movement of any power
equipment unit or attachment are the responsibility of the
purchaser. It is the purchaser’s responsibility to pay
transportation charges for any part submitted for replacement
under this warranty unless such return is requested in writing
by Greenworks.
6
English
EN
Shouldn't this be the cheaper 4
blade version not the 5?
-it's 5 blades
To Next Page
Loading...
Need help?
General
