Indoor Unit
85
Super Match
For AC12~24CS1ERA(S)
2.7
Installation
WARNING
CAUTION
Please ask the dealer or specialist to install, never try by the users themselves. After the installation please be sure
of the following conditions.
■ Please call dealer to install the air-conditioner. Incorrect installation may cause water leaking, shock and re
hazard.
■ Air-conditioner can’t be installed in the environment with inammable gases because the inammable gases near
air-conditioner may cause re hazard.
■ Installed electrical-leaking circuit breaker.
It easily cause electrical shock without circuit breaker.
■ Connect earthing wire.
Earthing wire should not be connected to the gas pipe, water pipe, lightning rod or phone line, incorrect earthing
may cause shock.
■ Use discharge pipe correctly to ensure efcient discharge.
Incorrect pipe use may cause water leaking.
■ Wiring
Air-conditioner should be equipped with special power supply wire.
■ Location
■ Air-conditioner should be located in well-vented and easily accessible place.
■ Air-conditioner should not be located in the following places:
(1) Places with machine oils or other oil vapours.
(2) Seaside with high salt content in the air.
(3) Near hot spring with high content of sulde gases.
(4) Area with frequent uctuation of voltage e.g. factory, etc.
(5) In vehicles or ships.
(6) Kitchen with heavy oil vapour or humidity.
(7) Near the machine emitting electric-magnetic waves.
(8) Places with acid, alkali vapour.
■ Choose the following locations:
(1) Capable of supporting air conditioner weight, don’t increase operating noise and vibration.
(2) Hot vapour from outdoor unit outlet and operating noise don’t disturb neighbour.
(3) No obstacles around the outdoor unit outlet.
■ TV, radio, acoustic appliances etc. are at least 1 m far away from the indoor unit, outdoor unit, power supply wire,
connecting wire, pipes, otherwise images may be disturbed or noises be created.
■ As required, take measures against heavy snow.
INSTALLATION PARTS
The following installation parts are optional parts. Use
them as required.
Optional parts
Adhesive tape Drain hose
Saddle (L.S) with screws Piping hole cover
Heat insulation material Plastic clamp
Putty