20
End of programme
Six beeps will indicate that the wash cycle has finished and the time-remaining indicator “ 10 “ changes
to “
: ”.
Switching the dishwasher OFF
Several minutes after the programme has ended:
Open the door when the programme has ended:
Set ON-OFF Button “A” to OFF.
Turn the water tap off. (Does not apply when Aqua-Stop unit has been fitted)
Remove dishes, etc. when they have cooled down.
Interrupping the programme
Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open
the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds, and the time
remaining indicator “ 10 ” changes to “ ” to tell you the door is open.
If the appliance has already heated up or the hot water was switched ON and then the appliance door
opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may
open due to expansion.
10
10
To Next Page
Loading...
Need help?
General
