10
EnglishEnglish
• Dryer must be exhausted outside (outdoors, not beneath the mobile home) using
metal ducting that will not support combustion. Metal ducting must be 4 inches
(10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred.
• If dryer is exhausted through the floor and area beneath the mobile home is
enclosed, the exhaust system must terminate outside the enclosure with the
termination securely fastened to the mobile home structure.
• Refer to previous pages for other important venting requirements.
• Installation must conform to current Manufactured Home Construction & Safety
Standard (which is a Federal Regulation Title 24 CFR-Part 32-80) or when such
standard is not applicable, with American National Standard for
Mobile Homes.
Warning: The dryer is designed under ANSI Z21.5.1 standard
for home use only.
Installation in Mobile Home
DO
Correct
DON’T
Incorrect
DO
Correct
DON’T
Incorrect
To Next Page
Loading...
Need help?
General
