Haier HLT10 User Manual

REMOTE CONTROL PREPARATION
BATTERY INSTALLATION
Install the battery as shown below. Be sure negative and positive terminals are
positioned as indicated in the battery compartment.(Fig1 )
SERVICE LIFE OF BATTERIES
-The batteries normally last for about one year although this depends on how often, and
for how long the remote control is used.
-If the remote control fails to work even when it is operated near the player, replace the
batteries.
-Use one size CR2025 battery.
Note:
Do not drop or step on the remote control. This may damage the
parts or lead to malfunction.
If the remote control is not going to be used for a long time, remove the battery.
REMOTE CONTROL
OPERATION
Point the remote control from no
morethan about 6 meter from the
remote control sensor and within
about 60o of the front of the
player(Fig2).
NOTE:
-The operating distance may vary
according to the brightness of the
room.
-Do not point bright lights at remote
control sensor.
-Do not place objects between the
remote control and the remote
control sensor.
-Do not use this remote control
while simultaneously operating the
remote control of any other
equipment.
MAIN MENU
• The unit contains different setting menus. Once the initial programming is entered it is retained in
memory until changed, the TV can always be operated under the same conditions.
• The settings will be retained in the memory until the settings are changed even after setting the player
to the standby mode.
Note: Please make sure either the unit is connected on the battery is charged to retain memory.
Initial settings
1.Press MENU button.
2. Use the left or right button to select preferred page, each page has Sub Menu to select different
setting. Then move the up or down button to set.
3.Press MENU button again to return to current setting item.
4.Press EXIT to close the setting menu .
1. PICTURE SETUP
-Press the MENU button the screen will display:
-When the menu displays on the screen, press the MENU button again to exit.
-Press EXIT to exit all menus.
Picture mode
Press up or down button to select, then press left or right button to set the picture mode
as Personal, Standard, Dynamic or Soft.
Contrast/Brightness/Sharpness/Tint/Color
-Press up or down button to select Contrast/Brightness/Sharpness/Color,then press left or
right button to adjust..
-The Contrast/Brightness/Sharpness/Color can be adjusted from 0-100.
-The Tint can be adjusted from -50 to 50.
15 10

Haier HLT10 Specifications

General

Brand	Haier
Model	HLT10
Category	LCD TV
Language	English