INFO(INFORMATION)
It is used to display current program information.
-Press INFO button, the screen will display as below:
CC(CLOSED CAPTION)
It is used to set the caption mode.
-Press CC button, the screen will display as below:
-Keep pressing this button to select different item as desired.
-Options: Off/ On /CC On Mute
EPG (ELECTRONIC PROGRAM GUIDE)
It is shows you the program guide for the part and future:
Informatin in the EPG includes current and future program titles, dates, show lengths,
and episode summaries. How far into the future the program guide displays, as well as
teh specific information contained in the guide, depends on your signal provider.
Press the right navigation button to access future time slots.
When viewing a digital channel, press the EPG button on the remote control to access
the program guide supplied by the signal provider ( not available in all areas).
OPERATION
MAKE SURE ALL THE EQUIPMENTS AND AC ADAPTOR ARE
CONNECTED PROPERLY AND THE UNIT IS SET IN CORRECT
MODE BEFORE OPERATING.
1. Programming the channels
-Make sure that all connections are connected proporly.
-Switch the unit to on.
-Later the screen will display as below:
-Press left or right button to select YES and press enter button to start scanning the channels.
-Available channel will be memoried automatically.
Manual programming using remote control:
- Press MENU button and scroll to channel by using VOL+ key and select ANTENNA by CH- change air
or cable by selecting VOL+, or selected scroll down to Auto Scan by using CH- and press VOL+ twice to
select Auto Scan.
NOTE:
You must scan channel before watching for the first time, or there is no program shown, or it show not
database.
2. BASIC OPERATION
To Select Channel:
1. Press CH + button to play next channel.
2. Press CH - button to play previous channel.
3. Press numeric but tons on the remote control directly to select your preferred channel.
Example: To watch channel 9, press "9" ,three seconds later, it will automatically switch to channel 9, or
press ENTER button to confirm directly.
To watch channel 12, press "1" and "2", three seconds later, it will automatically switch to channel 12, or
press ENTER button to confirm directly.
Note: If one frequence dot has more than one channel, for example, you want select < 14.2 >, Press 1
and 4, then press -/-- and input 2.Once the input is done, it will start broadcasting the selected channel
immediately.
VOLUME CONTROL
1. Press the V+ or V- to adjust the level of currently volume.
2.The level of VOLUME can be adjust from 0-30.
11 14
To Next Page
Loading...
Need help?
General
