6.CHANNEL SETUP
Press left or right button to enter setup page:
Antenna
It is used to set the type of signal reception.
-Press up or down button to select it and then press left or right button to set.
-Options: Air /CATV.
Auto Scan
Before normal watching you must search for the available channels.
-Press up or down button to select it and press ENTER to get in scanning setup page:
GENERAL PARTS AND CONTROLS
MAIN UNIT
FRONT VIEW
1.TFT SCREEN
2.BUILT-IN SPEAKER
3.POWER INDICATOR
4.REMOTE CONTROL SENSOR
5.MENU BUTTON-To enter menu setting
page.
6.CH+/∧BUTTON-To select next
channel or move up in menu mode.
7.CH-/∨ BUTTON-To select previous
channel or move down in menu mode.
8.VOL-/＜ BUTTON- To adjust the
volume lower or move left in menu mode.
9.VOL+/ ＞ BUTTON-To adjust the volume
louder or move right in menu mode.
10.ENTER BUTTON- it is used a to confirm
a selection.
11. STANDBY-To switch the unit to standby
mode.
SIED VIEW
12.ANTENNA
13.headphone jack-Connect to
headphone for private listening.
14.AV in jack- use the unit as a monitor.
15.DCIN 9-12V input jack
16.POWER switch
17.CHARGE INDICATOR
5 20
To Next Page
Loading...
Need help?
General
