5- Use
GB
5.1 Before rst use
▶ Remove all packaging materials, keep them out of children`s reach and dispose
them in an environmentally friendly manner.
▶ Clean the inside and outside of the appliance with water and a mild detergent before
putting any food in it.
▶ After the appliance has been levelled and cleaned, wait for at least 2 hours before
connecting it to the power supply. See Section INSTALLATION.
▶ Precool the compartments at high settings before loading with food. The function
Super Cool and Super Freeze helps to cool down the compartments quickly.
▶ The refrigerator temperature and freezer temperature are automatically set to 5° C
and -18° C respectively. These are the recommended settings. If desired, you can
change these temperatures manually. Please see ADJUST THE TEMPERATURE.
Notice: Presettings
▶ The appliance is preset to the recommended temperature of 5°C (refrigerator) and
- 18°C (freezer). Under normal ambient condition you need not to set a temperature.
▶ When the appliance is switched on after disconnection from the main power supply, it
may take up to 12 hours for the correct temperatures to be reached.
12
5.3 Switch on /of the appliance
The appliance is in operation as soon as it is connected to the power supply.
When the appliance is powered on for the rst time, freezer temperature is shining on the
display “b”until the temperature reaches -5°C or after 1 hour working. The temperatures
displayed will shown the actual temperatures in the compartment.
Maybe the panel lock is active.
Empty the appliance before switching o. To switch o the appliance,pull the power cord
out o the power socket.
5.4 Standby-mode
The display screen turns o automatically 30 seconds after touching a key or if one of the
doors is open longer than 30 seconds. The display will be automatically locked. It lights up
automatically by touching any key or opening one of the doors.
5.2 Sensor keys
The keys on the control panel are sensor keys, which already respond when lightly touched
with the nger.
To Next Page
Loading...
Need help?
General
