GB
7- Equipment
7.3 Bottle holder- freezer compartment
The bottle holders of the freezer compartment are intended for temporary storage of
spirits with a high alcohol content. Beverage without high alcohol should be cooled in the
fridge.
Additionally you can store small parts in the bottle holders.
Notice: Shelves
Ensure that all ends of a shelf are level.
WARNING!
Bottles and cans may burst! Set a timer that will remind you to remove bottles/cans
without high alcohol content.
21
7.4 Removable drawer
To remove the drawer out of the fridge or freezer com-
partment pull out to the maximum extent (1), lift and
remove (2) (Fig. 7.4).
In order to insert the drawer, the above steps are car-
ried out in reverse order.
1
2 2
7.1 Adjustable shelves
The height of the shelves can be adjusted to t your
storage needs.
1. To relocate a shelf, remove it rst by uplifting its
hind edge (1) and pulling it out (2) (Fig. 7.1).
2. To reinstall it, put it on the lugs on both sides and
push it to the most rearward position until the rear
of the shelf is xed inside the slots in the sides
7.2 Removable door racks/bottle holder
The door racks/bottle holder can be removed for
cleaning:
1. Place hands on each side of the rack/holder and lift
it upwards (1) (Fig. 7.2).
2. Pull the door rack/bottle holder out (2).
3. In order to insert the door rack/bottle holder, the
above steps are carried out in reverse order.
1
2
1
7.1
7.2
7.4
To Next Page
Loading...
Need help?
General
