Outdoor
Unit
Loading of the battery
1
2
3
4
Parts and Functions
Indoor Unit
Actual inlet grille may vary from the one shown in the
manual according to the product purchased
OUTLET
INLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
Remote controller
Remove the battery cover;
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
is in line with th
e" + "/"-";
Load the battery,then put on the cover again.
Inlet grille
Inlet
Air Purifying Filter
Outlet
Horizontal flap
Display board
(adjust up and down air flow
Don't adjust it manually)
(adjust left and right air flow)
Vertical blade
Emergency
Switch
Anion generator
(inside)
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change-over
wireless telephone is installed in the
ver is apt to be disturbed in receiving
the signals,
so the distance to the indoor unit should be sho
rter.
type fluorescent lamp or
room, the recei
Note:
Full display or unclear display during operation indicates the
ries have been used up.
Please change batteries.
If the remote controller can't run normally during operation, please
reload several minutes later.
batte
rem
ove the batteries and
Hint:
Operation mode
AUTO
FAN
COOL DRY
Remote controller
HEAT
LOW HI
MED AUTO
If pressed, the other buttons
will be disabled. Press it once
again,lock will be cancelled.
30
.
LOCK
button
When the remote
RESET
button
controller appears
abnormal, use a sharp
pointed article to press
this button to reset the
1
.
Control the lightening and
the indoor
extinguishing of
LED display board.
remote controller normal.
2.LIGHT button
3. TIMER button
4. CLOCK button
8. HEALTH button
6. MODE button
7. HOUR button
9. ON/OFF button
10. TIMER ON display
11. FAN SPEED display
12. LOCK display
13. SWING UP/DOWN display
14. SLEEP display
15. HEALTH display
16. Operation mode display
17
.Singal sending display
18. POWER/SOFT display
19. Left/right air flow display
20. TEMP display
21. TIMER OFF display
22. TIMER display
23. TEMP button
24. FAN button
25. HEALTH AIRFLOW button
26. SWING UP/DOWN button
27. SWING LEFT/RIGHT button
5. SLEEP button
28. SET button
29. POWER/SOFT button
2
NOTE:
30
28
19
F
AB
UsetoselectCODEAorBwhich
will be displayed on LCD. Please
select A without special explanation.
31
.
CODE
button
CODE
31
C
.5
Cooling only units do not have the functions and displays related
with heating.
The following functions and related displays are not available:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.
4
Display board FOR:09K 12K
F
F
TEMP display
COOL display
HEAT display
HE
ALTH display
Dry display
TIMER ON/TIMER OFF display
SLEEP display
AUTO display
Remote signal receiver
Display board FOR:18K
Display board FOR:24K
To Next Page
Loading...
Need help?
General