EN
11-Installation
29
11.1 Preparation
▶ Take the appliance out of the packaging.
▶ Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port-
hole. This normal phenomenon results from water tests in the factory.
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environmen-
tally friendly manner.
Note: Noise reduction pad
Noise reduction pad is optional , could help to reduce noise , please assemble it or not
according to your own demand.
11.2 OPTIONAL: Install noise reduction pads
1. When opening the shrink package, you will fi nd
some noise reduction pads.These are used for re-
ducing noise (Fig. 11-1).
2. Lay the washing machine down to its side, porthole
pointing upwards, bottom side towards operator
(Fig. 11-2).
3. Take out the noise reduction pads and remove
the double-sided adhesive protective fi lm; paste
around the bottom; the noise reduction pads un-
der the washing machine cabinet as shown in Fig.
11-3 (two longer pads in position 1 and 3, two
shorter pads in position 2 and 4). Finally set the
machine upright again.
11-1
11-2
11-3
2x
2x
To Next Page
Loading...
Need help?
General