9-Troubleshooting
GB
22
9.2 Troubleshooting with display code
Problem Cause Solution
•
Drainage error.
•
• Check drain hose installation.
E2
• Lock error. • Shut the door properly.
•
•
Drain hose is self-syphoning.
•
Make sure that tap is fully opened and water
pressure is normal.
•
Check drain hose installation.
•
Water protective level error. • Contact the After sales service.
of a problem please check all shown possibilities and follow below instructions before you
contact an after sales service. See CUSTOMER SERVICE.
WARNING!
▶ Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
▶
improper repairs can cause considerable consequential damages.
▶ A damaged power cable should only be replaced by the manufacturer, its service
9.1 Information codes
Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code Message
1:25
The remaining wash cycle time will be 1 hour and 25 minutes.
6:30
The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 min-
utes.
P--1/2/3
1/ 2/3 additional rinses are choosen (see FUNCTION BUTTONS “Extra rinse“).
End
cLo1-
Function child lock is activated.
Loc
Door is closed because of high water level, high water temperature or spinning cy-
cle.
bEEP OFF
The buzzer is deactivated.
bEEP ON
The buzzer is activated.
SPEEd
CLR FLTR
up
Function “Speed up” is activated.
Water level not reached.
1-
To Next Page
Loading...
Need help?
General
