Installation
EN-10 TV LED-TFT Owner’s Manual
Note
When connecting with external audio equipments, ❏
such as amplifers or speakers, please turn the TV
speakers o.
!
Caution:
Do not look into the optical output port. Looking •
at the laser beam may damage your vision.
Connecting a computer
How to connect
To get the best picture quality, adjust the PC graphics A
card to 1280s 1024.
Use the TV’s VGA or DVI (Digital Visual Interface)B
and AUDIO IN port for computer connections,
depending on your computer connector.
If the graphic card on the computer does not •
output analog and digital RGB simultaneously,
connect only one of either PC IN or HDMI IN to
display the VGA on the TV.
If the graphic card on the computer does output •
analog and digital RGB simultaneously, set the TV
to either VGA or HDMI.
Then, make the corresponding audio connection. If
C
using a sound card, adjust the PC sound as required.
How to use
Turn on the computer and the TV.A
Use INPUT on the remote control to select PC or B
HDMI source.
Check the image on your TV. There may be noise
C
associated with the resolution, vertical pattern,
contrast or brightness in PC mode. If noise is present,
change the PC to another resolution, change the
refresh rate to another rate or adjust the brightness
and contrast on the menu until the picture is clear.
If the refresh rate of the PC graphic card can not be
changed, change the PC graphic card or consult the
manufacturer of the PC graphic card.
Note
Avoid keeping a fixed image on the TV’s screen ❏
for a long period of time. The fixed image may
become permanently imprinted on the screen.
The synchronization input form for Horizontal and ❏
Vertical frequencies is separate.
To Next Page
Loading...
Need help?
General
