- 37 -
8.1 How to enter into the factory m
1. You can press "source-2-5-8-0" to go into factory setting. Presse the key "exit"
to shut the factory setting.
content:
1: ADC setup: set ADC value of YUV,VGA. It can also be auto-set. Adopt 100%
color bar to yuv and Checkerboard signal to vga.
2:Adjust the brightness and contrast ratio of each signal, which do not affect the
value of user's menu.
3: adjust the color temperature and white balance of each signal source.
4: SSC to adjust the spectrum for passing the EMC test.
5:special set
1)2hour off-- for Aging test
2)WDT --watch dog
3)white pattern --set pure color output for the panel, used at the checking and
aging test for panel.
4)reset
6)Aging--for Aging test.
6:PEQ set sound EQ
7:sw information: to check the sofeware information
8:UART DEBUG : Access to serial port and connect a computer if set to HK.
Service Manual
Model No.:
8.1 How to enter into the factory menu
5)set power-on screen display.
7)software update (USB).
To Next Page
Loading...
Need help?
General
