Page 5 of 33 V1.1
Disclaimer
The information in this manual is believed to be accurate, however, Hal Technology
assumes no responsibility for any inaccuracies that may be contained in this manual.
Under no circumstances will Hal Technology be liable for direct, indirect, special,
incidental, or consequential damages resulting from any defect or omission in this
manual, even if advised of the possibility of such damages. In the interest of continued
product development, Hal Technology reserves the right to make improvements or
changes in this manual and the products it describes at any time, without notice or
obligation.
Published in the United States of America
Copyright © 2016 by Hal Technology
All rights reserved. No part of the contents of this manual may be reproduced,
transmitted, stored, or translated into any other language in any form by any means
without the written permission of Hal Technology LLC.
Quality Assurance
• This product has met Hal Technologies product specifications. All the test
instruments and standard materials used for calibration are traceable.
• This certification is for new products only. It is not valid for previously
owned or exhibition units.
Commonly Used Symbols
The following symbols are used throughout this manual:
The action described could lead to harmful damage of the instrument.
To Next Page
Loading...
Need help?
General