EasyManuals Logo
Home>Hamax>Baby Carrier>OUTBACK

Hamax OUTBACK User Manual

Hamax OUTBACK
71 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
p. 13
Connect the two shoulder strap buckles together and insert them into the center buckle [16b] on the crotch strap [16d] until you
feel it snap. Reduce the length of the crotch strap and the shoulder belts so that your child is securely tightened. Verify that the
safety harness is locked by pulling both shoulder belts.
[17] Mounting the LED lights
Place the lights on the side of the trailer that is most exposed to the road.
Front: Aach the white LED light through the hole in the fabric.
Rear: Aach the red LED light on the push bar at the back of the trailer.
NOTE: LED lights can be purchased at your bicycle specialist store. Make sure they comply with the lighting regulations in
your country.
CARE AND MAINTENANCE
Check before using the trailer
The wheels are properly secured to the trailer.
The tires are inflated according the specified tire pressure
The trailer is unfolded properly and the mechanism is locked on both sides. Do not forget to lock the push bar.
The seat back rest is well secured and tightened. Please see the maintenance section.
The safety flag and lights are in place whenever required.
Storage
It is highly recommended to store the Outback trailer indoors, in a dry and well-ventilated area out of direct sunlight.
TIP: There is a Hamax storage cover available for beer protection.
Maintenance
Push bar: In case the push bar slips from its position, tighten the nut [18] under the fabric of the push bar. Make sure the nuts
are tightened equally on both sides.
Parking brake [2m]: Adjust the parking brake cable by seing the cable adjuster [19] near the brake pedal.
Safe connection point [2e]: If dirt is inside the safe connection point [2e], rinse it with water.
Seat base back rest [2j]: Regularly tighten the straps [20] at the rear of the seat base back rest. Make sure that you start to
tighten it at the top and follow by tightening it at the boom.
Do not use cleaning solvents. Clean only with mild soap and water.
The seat paddings [2d] can be removed from the trailer for cleaning purposes. Wash seating by hand or using cold machine
wash with a short spin cycle.
Allow the trailer to dry completely before storing it to prevent it from becoming moldy.
If the trailer is involved in an accident or is damaged, contact your dealer to check if it can still be used.
WARRANTY
The Hamax Outback Multifunctional Child Carrier is warranted from the date of purchase. The warranty period depends on the
law of the country in question. The warranty applies to defects in materials or workmanship, and does not cover damage due
to improper use, lack of maintenance, failure to follow the user manual, use of force or normal wear and tear. The warranty is
valid for the original user only. Please read the use and maintenance recommendations carefully. Conditions that may cause
premature wear of the carrier may not be covered by the warranty. Should the carrier require service or you want to make a
warranty claim, please contact your local dealer from whom you purchased your carrier.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hamax OUTBACK and is the answer not in the manual?

Hamax OUTBACK Specifications

General IconGeneral
MaterialAluminum
Product colorBlack, Grey
Number of seats2 seat(s)
Number of wheels3 wheel(s)
Belt fastening type5-point
Bicycle trailer typeChild
Quick release wheelsYes
Wheel size (imperial)20 \
Maximum weight capacity40 kg
Recommended genderAny gender
Number of pieces1 pc(s)