6
Connecting the sprayer
The sprayer is designed for three point suspension and is equipped
with 22 mm pivots (category I).
WARNING: Note the weight of the sprayer.
See section on Technical specifications.
Generally it is recommended to:
1. Add ballast to front of tractor.
2. Increase tyre pressure (see
tractor instruction book).
3. Travel at slower speeds when
driving with a full tank.
(The tractor will have decreased
braking efficiency.)
4. Be careful when filling/lifting the
sprayer the first time.
The pump is mounted directly
to the tractor P.T.O.
1. Undo the 2 allen screws
*
on
coupling and remove key.
2. Slide pump onto P.T.O.
shaft.
3. Replace key and tighten
allen screws.
4. Secure pump with supplied
chains to prevent rotation.
Roadworthyness
When driving on public roads and other areas where the highway code
applies, or areas where there are special rules and regulations for
marking and lights on implements, you should observe these and
equip implements accordingly.
*
To Next Page
Loading...
Need help?
General
