6
Pump
Check the pump belts are tight and the protection screen is in good
condition according to local law.
Is the pump the piston type
check oil level and fill on SAE
20/40 HD if necessary.
The oil level must be between
min. and max. mark on the dip
stick (2). Furthermore, the P3L
has an outside sight glass (2).
Adjustment of the M600/N 2 controls
P3X
1
2
1
1. Fill the sprayer tank with clean water.
2. Start the engine.
3. Turn main ON/OFF handle to spraying position 1A.
4. The pressure regulating valve 2 is set at the wanted pressure and
shown on the pressure gauge.
5. Open for the spray lance and set the pressure at 3 bar more than
normal working pressure to check possible leaks. Reduce the
pressure to normal working pressure.
1B
1A
1B
1A
2
2
To Next Page
Loading...
Need help?
General
