Hardi Navigator Series User Manual

15
HARDI NAVIGATOR
Transmission shaft
Shield renewal
The replacement of defective shields is done as follows:
1 Push down on the universal cross cover and press in
the tabs with a screwdriver. Maintain pressure until
all three tabs are released.
Fig 50
2 Remove the nylon bearing and pull off the protection
Fig 51
3 Grease the protection tube bearing groove on the
inner yoke.
Fig 52
4 Slide on the shield tube and fit the bearings tabs into
the slots.
Fig 53
5 Slide the universal cross cover over the protection
tube and align the grease nipple with the grease
channel on the bearing. Press the universal cross
cover onto the tabs until they lock.
Fig 54
6 Check alignment and locking of the tabs by tapping
the universal cross cover lightly.
Fig 55
Constant velocity joint shielding renewal
1 Remove the screws holding the two halves of the
shield together.
Fig 56
Fig 57
3 Lubricate the bearing surfaces on the central body of
the joint. Align the two halves of the shield and
secure with the screws.

Hardi Navigator Series Specifications

General

Brand	Hardi
Model	Navigator Series
Category	Farm Equipment
Language	English