SAFETY INFORMATION
Do Not Open the Cabinet
There are no user-serviceable components inside this product. Opening the
cabinet may present a shock hazard, and any modification to the product will
void your warranty. If water or any metal object such as a paper clip, wire or
staple accidentally falls inside the unit, disconnect it from the AC power source
immediately, and consult an authorized service center.
Installation Location
To ensure proper operation and to avoid the potential for safety hazards, •
place the unit on a firm and level surface. When placing the unit on a shelf,
be certain that the shelf and any mounting hardware can support the
weight of the product.
Make certain that proper space is provided both above and below the •
unit for ventilation. If this product will be installed in a cabinet or other
enclosed area, make certain that there is sufficient air movement within
the cabinet. Under some circumstances, a fan may be required.
Do not place the unit directly on a carpeted surface. •
Avoid installation in extremely hot or cold locations, or in an area that is •
exposed to direct sunlight or heating equipment.
Avoid moist or humid locations. •
Do not obstruct the ventilation slots on the top of the unit, or place objects •
directly over them.
Due to the weight of the • AVR 460/AVR 360 and the heat generated by
the amplifiers, there is the remote possibility that the rubber padding
on the bottom of the unit’s feet may leave marks on certain wood or
veneer materials. Use caution when placing the unit on soft woods or
other materials that may be damaged by heat or heavy objects. Some
surface finishes may be particularly sensitive to absorbing such marks,
due to a variety of factors beyond our control, including the nature of the
finish, cleaning materials used, and normal heat and vibration caused by
the use of the product, or other factors. We recommend that caution be
exercised in choosing an installation location for the component and in
normal maintenance practices, as your warranty will not cover this type of
damage to furniture.
Cleaning
When the unit gets dirty, wipe it with a clean, soft, dry cloth. If necessary, and
only after unplugging the AC power cord, wipe it with a soft cloth dampened
with mild soapy water, then a fresh cloth with clean water. Wipe it dry
immediately with a dry cloth. NEVER use benzene, aerosol cleaners, thinner,
alcohol or any other volatile cleaning agent. Do not use abrasive cleaners, as
they may damage the finish of metal parts. Avoid spraying insecticide near
the unit.
Moving the Unit
Before moving the unit, be certain to disconnect any interconnection cords
with other components, and make certain that you disconnect the unit from
the AC outlet.
Unpacking
The carton and shipping materials used to protect your new receiver during
shipment were specially designed to cushion it from shock and vibration. We
suggest that you save the carton and packing materials for use in shipping if
you move, or should the unit ever need repair.
To minimize the size of the carton in storage, you may wish to flatten it. This
is done by carefully slitting the tape seams on the bottom and collapsing the
carton. Other cardboard inserts may be stored in the same manner. Packing
materials that cannot be collapsed should be saved along with the carton in a
plastic bag.
If you do not wish to save the packaging materials, please note that the carton
and other sections of the shipping protection are recyclable. Please respect
the environment and discard those materials at a local recycling center.
It is important that you remove the protective plastic film from the front-
panel lens. Leaving the film in place will affect the performance of your
remote control.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
