page 4
T-Series Operation Manual
Wiring (continued)
Stereo (Dual) Wiring Using Binding Post Connectors
1� On the back panel, set the Output Mode Switch to STEREO.
2� Wire the speakers to the binding post connectors as shown.
Bridge-Mono Wiring Using Speakon
®
Connectors
Bridge-mono mode doubles the output power of the amplifier.
1� On the back panel, set the Output Mode Switch to BRIDGE.
2� Wire the speaker to the Speakon® connector as shown.
3� Only the Channel 1 Gain Control works in Bridge-mono mode.
T3
T3
To Next Page
Loading...
Need help?
General