Harman JBL BAR 9.1 Owner's Manual

1414
6.2.2 Charge through a USB cable
100%
Micro USB
• Use a USB cable to connect the detachable speakers to
power respectively.
• For the detachable speakers, the status indicator is used
for status indication of both battery power and wireless
connection (See “Detachable speakers” in the “PRODUCT
OVERVIEW” chapter).
NOTES:
− * The USB cable is sold separately.
6.3 Sound calibration
For sound calibration, do the following:
− Make sure that your room is quiet;
− Make sure that the soundbar and the two detachable rear speakers
are fully in sight of each other, without obstacles in between.
− Make sure that the left and right rear speakers are properly placed, the
L speaker on the left and the R speaker on the right.
6.3.1 Wireless surround sound
With the audio calibration, your surround sound
experience will be optimized for your favorite seating and
speaker positions.
1) Calibrate the listening zone
R
L
>5S
1-CALIBRATION
1DONE
1. Place the detachable rear speakers beside your seating
position.
• Make sure that the two detachable speakers have been
connected to the soundbar (See “Wireless connection”
under “Connect the detachable rear speakers” in the
“SETUP” chapter).
2. On the remote control, press and hold
until
“ ” is displayed on the soundbar.
→ Countdown starts from 5 to 1.
→ Calibration tone is heard. Audio calibration starts.
→ “
”: Calibration ongoing.
→ “
”: Calibration of the listening zone is completed
successfully.

Harman JBL BAR 9.1 Specifications

General

Brand	Harman
Model	JBL BAR 9.1
Category	Speaker System
Language	English