www.jbl.com
English
2121
3. To enter the software update mode, press and hold and - on
the soundbar for more than 10 seconds.
→ “
” is displayed.
→ “
”: Software updating underway
→ “
”: Software updating completed
→ The soundbar returns to the last selected source.
NOTES:
− Keep the soundbar powered on and the USB storage device mounted
before software updating is complete.
− ”
” is displayed if the two detachable
speakers are not properly mounted onto the soundbar.
− “
” is displayed if no USB storage device is detected,
and 5 minutes later, the soundbar exits the software update mode.
− “Error”is displayed if software updating has failed twice.
11. RE-CONNECT THE SUBWOOFER
The soundbar and subwoofer are paired at factories. After
power-on, they are paired and connected automatically. In some
special cases, you may need to pair them again.
POWER
POWER
4
2
3
1
To re-enter the subwoofer pairing mode
1. On the rear panel of subwoofer, press and hold until it turns
fast ashing white.
2. To enter the subwoofer pairing mode on the soundbar, press
and hold
on the remote control for more than ve seconds.
Press - on the remote control.
→ “
”: The subwoofer is ready for pairing.
→ “
”: The subwoofer is connected.
NOTES:
− The subwoofer will exit the pairing mode in three minutes if pairing and
connection are not completed.
turns from fast flashing white to
slow flashing white.
To Next Page
Loading...
Need help?
General
