10
2.0 Setup
2.1 Unpacking Your Amplier
Please unpack and inspect your amplier for any damage that may have occurred
during transit. If damage is found, notify the transportation company immediately.
Only you can initiate a claim for shipping damage. We will be happy to help
as needed. Save the shipping carton as evidence of damage for the shipper’s
inspection.
We also recommend that you save all packing materials so you will have them if you
ever need to transport the unit. Never ship the unit without the factory pack.
WARNING: Before you start to set up your amplier, make sure you read and
observe the Important Safety Instructions found at the beginning of this manual.
2.2 Installing Your Amplier
CAUTION: Before you begin, make sure your amplier is disconnected from the
power source and all level controls turned completely down (counterclockwise).
To install the amplier, you can use one of the following approaches:
• Rack mount the amplier with the rack mounting kit, see Figure 2.2.2.
• Place a single amplier on a surface with 12 inches of air space around
the unit for convection cooling. Rubber feet are included and can be
attached onto the underside of the chassis. For amplier dimensions,
see Figure 2.2.1.
To Next Page
Loading...
Need help?
General