Harman P43 Owner's Manual

Harman® • P-Series Owner’s Manual_R1 • 03/1416 3-90-436168c
SeeNote7
1"
Igniter Switch to “MANUAL” (down position) Make
suretheunitispluggedintoa120VAC,60Hzelectrical
source.Thepowerlightshouldbetheonlylightlit.
NOTE: Be sure there is no fuel or other combustibles in
the ash pan prior to lighting.
1.TurnFeedlimittodesiredfeedrate.No.4isgoodformost
pellets.
2.Turn the MODE SELECTOR to “OFF” and then to
the desired mode. This will reset control and start the
combustionmotor.
3.TurntheTEMPERATUREDIALtothedesiredsetting.
4.Cleanburnpotwithscraperifnecessary.
5.Fillburnpotwithpellets,onlylevelwithfrontedge.(Do
NotOverFill).
6.Addstartinggelontopofthepellets.Stirgelintopellets
forfastlighting.
7.Light starting gel with a match, and close the door.
Operation will begin when the re reaches the proper
temperature.
8.Fillhopperwithpelletsandremoveashesasrequired.
Storefuelinadryarea,awayfromallignitionsourcesand
outside all limits of the stove's clearance requirements to
combustibles.Do not storethefuel were itinterferes with
therefuelingofthestoveoremptyingofashes.Donotstore
any ashes removed from the stove near the fuel or other
combustiblematerials.
STARTER
GEL
1. Fines are small pieces of broken pellets (sawdust). Fines do
notoweasilyandoftenbuilduponthehopperfunnelbottom
angles.Thesenescanbepushedintothefeederopeningand
thenllthehopperwithpellets.Asthesystemworks,theywill
be burned.
2. The "TEST" cycle will operate the feeder motor for exactly one
minute. Turning to "TEST" again and again may load too much
fuel into the burn pot causing excessive smoke on start-up.
3. The low pressure switch will not allow the feed motor to operate
if the viewing door is open.
4.AdjustFeedRate.Ifthisisyourrstreoryouaretryingdifferent
pellets, set the feed limit to #4, Figure 4.8. This is a conservative
number and will probably need to be increased. After you know
a feed rate setting that works well, use that setting. Remember,
if your feed rate is too high you may waste fuel.
5. Setting the feed limit # for maximum burn: With the unit
burning in "AUTO",turn to "Stove Mode" and put the fan on
"H".SettheTemperatureDialto#7.Allowtheunittoburnfor
about 30 minutes and check ash on front of burn pot. Figure
4.9. If the ash line is larger than 1", turn the feed limit from #4
to #5. Allow another 30 minutes of burn time and check again.
If , at #6 setting, a 1" or less ash bed is not obtainable, it is not
a problem. The 1" ash bed is only at maximum burn rate and
during normal operation, the ash bed will be larger.
F. Manual Ignition
Figure 4.8
Figure 4.9
BURNING GARBAGE, USE OF IMPROPER FUELS,
FIRE STARTERS OR ALTERING THE STOVE FOR
HIGHER HEAT OUTPUT MAY CAUSE DAMAGE TO
THE STOVE AND COULD RESULT IN A HOUSE FIRE.
USE ONLY APPROVED FUELS AND FOLLOW ONLY
THESE OPERATION GUIDELINES.
WARNING
!
NEVER USE GASOLINE, GASOLINE-TYPE LANTERN
FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR
SIMILAR LIQUIDS TO START OR 'FRESHEN UP' A FIRE
IN THIS HEATER. KEEP ALL SUCH LIQUIDS WELL
AWAY FROM THE HEATER, WHILE IN USE.
WARNING
!

Harman P43 Specifications

General

Brand	Harman
Model	P43
Category	Stove
Language	English