20
PP38+ Pellet Stove
Whenever wood is burned slowly, the potential exists for creosote to form in the venting. The chimney or
venting system should be inspected periodically throughout the heating season to determine if a creosote
buildup has occurred. If a signicant layer of creosote has accumulated (3 mm or more), it should be removed
to reduce the risk of a chimney re. A professional chimney sweep is recommended, since they would normally
have the correct equipment to ensure proper creosote removal.
turn the stove to "OFF" to allow the unit to shut down. Call the
re department, and be sure everyone is out of the residence. Before re-using the appliance, have the venting
system thoroughly inspected and replace any damaged components.
The glass in your Harman stove is a special ceramic glass.
abuse the glass by striking or slamming the door.
burn the appliance if the door glass is cracked or broken.
• Replace with Harman supplied glass.
Soot and/or y-ash may accumulate on the viewing glass, and will occasionally need to be cleaned.
Clean the glass with a soft cloth and mild glass cleaner.
clean the glass when hot, and avoid the use of abrasive cleaners.
remove all remaining glass and
gasket materials prior to replacing the glass.
Lay the door face down on a at surface.
Remove the glass retainers and screws.
Apply the gasket material to the face of
the new glass. Lay the glass into the door,
making sure that the glass is contained
within the channels and raised areas of
the door itself. Lay the glass retainers into
position and install the screws. Tighten each
screw evenly to avoid making any stress
points.
Retainers and screws
Glass
Adhesive gasket
Door Frame
To Next Page
Loading...
Need help?
General
