HART HZUV01 User Manual

6 – English
NOTE: ILLUSTRATIONS START ON PAGE 7
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
REMOVING BLOCKAGES AND CLEANING THE
ROLLER BAR
See Figures 10 - 11, page 9.
 Unplugthevacuum.
 Placethevacuuminahorizontalpositionwiththedirt
cupfacingup.
Removethesixscrewssecuringthebrushcovertothe
rollerbar.
Pulltherollerbrushupandawayfromtherollerbar.
Cleantheinsideoftherollerbar.Clearanyobstructions
withabluntobject.
Cleantherollerbrush.Usescissorstoremoveanythreads
orhairwrappedaroundtherollerbrush.
Reassembletherollerbrushandbrushcover.
Securebrushcoverwithscrews.
MAINTENANCE
WARNING:
Whenservicing,useonlyidenticalreplacementparts.
Useofanyotherpartscouldcreateahazardorcause
productdamage.
GENERAL MAINTENANCE
Avoidusing solvents when cleaning plastic parts. Most
plasticsaresusceptibletodamagefromvarioustypesof
commercialsolventsandmaybedamagedbytheiruse.Use
cleanclothstoremovedirt,dust,oil,grease,etc.
WARNING:
Donotatanytimeletbrakefluids,gasoline,petroleum-
basedproducts,penetratingoils,etc.,comeincontact
withplasticparts.Chemicalscandamage,weakenor
destroyplasticwhichcouldresultinseriouspersonal
injury.
POWER SUPPLY CORD REPLACEMENT
Ifreplacementofthepowersupplycordisnecessary,this
mustbedonebyanauthorizedservicecenterinorderto
avoidasafetyhazard.
CLEANING/REPLACING THE FILTERS
See Figures 12 - 15, page 9.
For the pre-motor filter:
 Unplugthevacuumandremovethedirtcup.
 Pullthefilterframeandpre-motorfilterawayfromthe
vacuumusingthepulltab.
Separatethepre-motorfilterfromthefilterframe.
Cleanthepre-motorfilterandfilterframewithwarmsoapy
water.Rinseandletdrycompletely.
NOTE:Ifthepre-motorfilterisdamaged,itshouldbe
replaced.
Reinstallpre-motorfilterandfilterframe.
NOTE:Makesurethefilterisseatedproperlyinsidethe
frame.Installingthefilterincorrectlywillallowdirttoenter
themotor,causingrapidmotorwear.
Replacethedirtcup.
NOTE: When purchasing a replacement pre-motor filter,
requestrecommendedpartnumber029516001002.
For the HEPA filter:
Squeezethelatchtoreleasetheexhaustcover.
Removetheexhaustcover.
PressdownonthetabatthetopoftheHEPAfilterand
removethefilter.
Shakeorlightlybrushanydustordirtoffthefilter.
ReinstalltheHEPAfilterwiththetabfacingup.
PlacetheexhaustcoverovertheHEPAfilter,thensnap
itintoplace.
NOTE: WhenpurchasingareplacementHEPAfilter,request
recommendedpartnumber029516001001.

HART HZUV01 Specifications

General

Brand	HART
Model	HZUV01
Category	Vacuum Cleaner
Language	English