Port Name: This is the name of your printer port. Each printer
port needs to be assigned a name. The client utility uses this
name to access the printer port.
Upgrade Firmware: You can use the “Upgrade Firmware” tool
to update to the newest firmware of the print server. Click the
button and select the correct firmware version file. After
selecting the firmware file, click the “Upgrade” button to
finish the firmware update process.
Wireless Function: You can select “Enable” or “Disable” to
manually enable or disable the wireless functionality of the
HWPS1UG Print Server. If you manually enable the wireless
functionality, the print server’s wireless LAN will be always
enabled and Ethernet will be disabled. If you manually disable
the wireless functionality, the print server’s wired LAN
connection will be always enabled and all wireless
functionality will be disabled. You also can select “Auto” to
let the print server automatically decide to enable or disable
the wireless functionality. The print server can only work in
ether Ethernet or wireless LAN mode. It cannot work in both
Ethernet and wireless LAN mode at the same time. When the
print server initially boots up, it will auto-detect if the LAN
port is connected to an active network through the Ethernet
cable. If the print server is connected to an active network
through the Ethernet cable when booting up, the print server
will run in Ethernet LAN mode (Wired). If the print server is
not connected to an active network through an Ethernet cable
when booting up, the print server will run in wireless LAN
mode (Wireless). The HWPS1UG’s default setting is to run in
“Auto” mode.
To Next Page
Loading...
Need help?
General
