HELLER HPAC10 User Manual

Maintenance
Note: Turn off the unit and unplug it before any maintenance or repair, in order to avoid electric shock.
Cleaning
• Unplug the unit before any cleaning.
• Clean the housing with a soft damp cloth. Do not use chemical solvents (such as benzene, alcohol, or
gasoline). The surface may become damaged or deformed.
• Do not sprinkle water on the unit.
Air filter
• Clean the air filter every 2 weeks. If the air filter is blocked with dust, the efficiency will be reduced.
• Push the air filter cover upwards, and then take out the air filter.
• Wash the air filter by immersing it gently into warm (about 40°C) water with a neutral detergent, rinse
and dry thoroughly in a shaded area.
End of season
• Please drain the water.
• Run the unit on Fan mode for two hours until the inside of the unit is dry.
• Turn off the unit and unplug it.
• Clean the air filter, and after it has dried thoroughly, reinstall it.
• Remove the exhaust pipes and keep them in a safe dry place.
• Wrap the unit in a plastic bag and keep it in a dry place.

HELLER HPAC10 Specifications

Operating Environment

permissible excessive operating pressure (suction)	1.5 MPa
permissible excessive operating pressure (discharge)	5.5 MPa
maximum allowable pressure (low pressure side)	1.7 MPa
maximum allowable pressure (high pressure side)	5.5 MPa

Power

power supply	220-240 V / 50 Hz
rated input (cooling)	1050 W

Performance

cooling capacity	2.93 kW
air flow	360 m3/h
noise	55 dB(A)

Refrigerant

refrigerant type	R410a
refrigerant charge	500 g

Weight and Dimensions

net weight	25 kg
gross weight	30 kg
dimensions (WxHxD)	433 x 795 x 330 mm