Power Memory Settings
The dome can resume its previous PTZ status after it restarted from a power-off when it stops at a
position longer than the predefined time. You can set the memory time to 10S, 30S, 60S, 180S, and
300S.
Coaxitron Control
The Coaxial transmission function can be enabled to transmit the RS485 signal along with the video
signal via the BNC cable. If the connected encoding device also supports the Coaxial transmission,
the RS485 cable will not be necessary.
Steps:
1) Enable the Coaxial control function by setting the option of COAXITRON ACT to ON.
2) Select the Coaxial control protocol, with HIK-C is selectable.
The transmission protocol of the connected encoding device should be set the same as the
speed dome to support the coaxial transmission.
3.3 Configuring Image Parameters
3.3.1 Configuring Camera Parameters
Purpose:
You can set the camera parameters including focus, shutter speed, iris, etc.
Enter the camera parameters settings menu:
MAIN MENUS > SYS SETTINGS >CAMERA PARAMETER
To Next Page
Loading...
Need help?
General
