User Manual of HD-TVI Speed Dome
© Hikvision
2. Choose the task number.
Steps:
(1) Move the cursor to TASK NO. and click IRIS+ to enter edit mode.
(2) Click the up/down direction buttons to select the number of the task which is to be
configured.
(3) Click IRIS+ again to confirm the settings and exit the edit mode.
Up to 8 time tasks can be configured.
3. Set the task status.
Steps:
(1) Move the cursor to ENABLE TASK and click IRIS+ to enter edit mode.
(2) Click the up/down direction buttons to set the task status to ON.
(3) Click IRIS+ again to confirm the settings and exit edit mode of this column.
If the task action and task time have not been configured, you cannot set the status as ON.
4. Configure the task action.
Steps:
(1) Move the cursor to TASK ACT and click the IRIS+ to enter edit mode.
(2) Click the up and down direction buttons to select the task action from preset 1~8, pattern
1~5, patrol 1~10, pan scan, tilt scan, panoramic scan, day mode, night mode, zero calibrate
and none.
(3) Click IRIS+ again to confirm the settings and exit edit mode of this column.
5. Set the task time.
Steps:
(1) Move the cursor to TASK TIME and click IRIS+ to enter edit mode.
(2) Click the left and right direction buttons to position the cursor to WEEK, START (H-M) and
END (H-M).
(3) Click the up and down direction buttons to set the start time and end time to run the time
task.
(4) Click IRIS+ to confirm the settings and exit.
The weekday can be set to be from Monday to Sunday or Whole Week; the H refers to
Hour and the M refers to Minute.
To Next Page
Loading...
Need help?
General
