4.2 Easy Wi-Fi Connection with WPS function
Purpose:
The setting of the wireless network connection is never easy. To avoid the
complex setting of the wireless connection you can enable the WPS function.
WPS (Wi-Fi Protected Setup) refers to the easy configuration of the encrypted
connection between the device and the wireless router. The WPS makes it easy to
add new devices to an existing network without entering long passphrases. There are
two modes of the WPS connection, the PBC mode and the PIN mode.
Note: If you enable the WPS function, you don’t need to configure the parameters
such as the encryption type and you don’t need to know the key of the wireless
connection.
Steps:
Figure 4-7 Wi-Fi Settings - WPS
PBC Mode:
PBC refers to the Push-Button-Configuration, in which the user simply has to
push a button, either an actual or virtual one (as the button on the
configuration interface of the IE browser), on both the Access Point (and a registrar
of the network) and the new wireless client device.
1. Check the checkbox of to enable WPS.
2. Choose the connection mode as PBC.
Note: Support of this mode is mandatory for both the Access Points and the
connecting devices.
3. Check on the Wi-Fi router to see if there is a WPS button. If yes push the
button and you can see the indicator near the button start flashing, which
means the WPS function of the router is enabled. For detailed operation,
please see the user guide of the router.
4. Push the WPS button to enable the function on the camera.
To Next Page
Loading...
Need help?
General
